globalhaa.blogg.se

For a Windows PC, EPOC uses a standard USB HID driver system and will self-install the first time it is inserted into a USB port.

5 2.2 Installation Please see the detailed installation instructions supplied in the SDK and User manuals. The LED will appear red during battery charging when the battery is fully-charged, the LED will display green. When the power switch is set to the on position, the LED will illuminate and appear blue if there is sufficient charge for correct operation. The neuroheadset contains a status LED located next to the power switch at the back of the headband. However, please note that this method takes substantially longer to charge the battery. Using the battery charger, a fully drained battery can be recharged to 100% capacity in approximately 100 minutes charging for 15 minutes usually yields about a 10% increase in charge.Īlternatively, you may recharge the neuroheadset by connecting it directly to a USB port on your computer. To charge the neuroheadset battery, set the power switch to the off position, and plug the neuroheadset into the Emotiv battery charger using the mini-usb cable provided with the neuroheadset. 4 Figure 1 Emotiv SDK Setup For more detailed hardware setup and neuroheadset fitting instructions, please see the Emotiv SDK Hardware Setup.pdf file shipped to SDK customers Charging the Neuroheadset Battery The neuroheadset contains a built-in battery which is designed to run for approximately 12 hours when fully charged.

Please download the consumer manual here.ġ Emotiv TestBench User Manual 2 TABLE OF CONTENTS 1. Both Emotiv Testbench and OpenSesame are supposed to be linked with a physical serial port to receive. Event synchronization between OpenSesame and Emotiv EEG.